In Stock

Why is Haas charging $300 for a piece of round bar with a hole in the middle? Or Renishaw $120?

You’re looking at a spared-every-expense, no-frills 1.00, 1.50, or 2.00 inch tool probe riser block. Yes, you could certainly make this in an hour in your shop from scrap—but if you’d rather not spend the time but don’t want to pay much more than the material cost, here’s one that’s already done. This is made to be dirt cheap, so there are almost no features. No locating pins, no grinding, no impressive tolerances.

FEATURES

• Fits ⌀2.46 inch OTS base (also RTS, TS27R to name a few)

• Raises base 1.00, 1.50, or 2.00 inches

• Boss on bottom for stacking—stack multiple risers for extra height

• Not Included: 1/2”-13 socket cap screw for mounting. Order from McMaster, just add 1” to the height of your riser(s).