You’re looking at a spared-every-expense, no-frills 1.0, 1.5, or 2.0 inch tool probe riser block. Yes, you could certainly make this in an hour in your shop from scrap—but if you’d rather not spend the time but don’t want to pay much more than the material cost, here’s one that’s already done. This is made to be dirt cheap, so there are almost no features. No locating pins, no grinding, no impressive tolerances.
Fits ⌀2.46 inch Renishaw OTS base (also RTS, TS27R to name a few)
Raises probe 1.0, 1.5, or 2.0 inches
Boss on bottom for stacking—stack as many risers as you need
Not Included: 1/2”-13 socket cap screw for mounting. Order from McMaster, just add 1” to the height of your riser(s).
- As-machined bare aluminum finish